How to make a K'NEX V6 engine

Today I'm going to show you how to make a V6 engine out of K'NEX. You will need to gather plenty of peices, including connectors, and other rods. (Don't forget the panels and sockets). Also there is some other pictures of some of my other K'NEX creations too. And the last picture is my cat =-).

Step 1: Step 1

You will need a variety of K'nex parts, which include connectors, rods, sockets, and panels.
                                                                                                                                                                                                                    
Rods:
Yellow (7)
Red (12)
Blue (2)
White & Grey (54)
Long Grey (6)
       
Connectors:
White (12)
Grey (18)
Black socket (8)
Black (6)
Double blue snowflake (8)
Half + Double blue & grey snowflake (8)
Tan clips (6)
Snowflake (10)
Half yellow snowflake (12)

 Panels:
Black & Blue small (8)
Large Blue (4)
 
Spacers:
Silver/Grey (3)
Blue (6)

Comments

[daredevil499]

this has nothing to do with the instructble but how do you make a step without a picture? when I made my instructable it says I need to have at least one picture in each step. and good instructable.

[KNEX-pert]

Great engine! Your instructions were simple and clear. =-)

[K'nex gun builder]

I didn't have the proper pictures for the instructable. I was only able to post the instructable by adding pictures of my other creations, including my kitty =-)

[jbouffard]

not really an engine but good instructable !

[The Jamalam]

It's not an instructable though, there's no pictures on each step.

[~KGB~]

lol, no pics in each step XD

[K'nex gun builder]

I know it's not the WHOLE engine. I researched and found out it is actually the BOTTOM of the engine.

[K'nex gun builder]

I tried, but thanks. =-)