Print PDF
Favorite
Email
Step 2Change Mr. Potato Head's stance
For placement purposes, I drew in some eyes on my potato head. Then, I drew a circle on each side where I wanted my legs to sprout from. I wanted to be mindful of the areas that would be covered up or cut out.
Next, I used a household dremel tool to cut a hole on each side of the body. Then, I attached the two metal pipes to a small plastic beam inside of Mr. Potato Head.
This is a picture of my potato head from the back. The three holes along the middle were part of the original toy design.
Next, I used a household dremel tool to cut a hole on each side of the body. Then, I attached the two metal pipes to a small plastic beam inside of Mr. Potato Head.
This is a picture of my potato head from the back. The three holes along the middle were part of the original toy design.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
