NOTE THAT THIS IS A TOBACCO AND SHISHA PIPE ONLY!
I WILL NOT BE HELD RESPONSIBLE FOR ANY ILLEGAL SUBSTANCES BEING SMOKED IN THIS PIPE, OR INJURY RESULTING FROM SMOKING THIS PIPE.
SMOKING IS BAD FOR YOU! DON'T DO IT! NOT FOR USE OF MINORS (UNDER 18 IS PROHIBITED)
For this project you will need:
A piece of wood about 1 inch square by about 4 inches(can be larger if desired.)
A 3/4 inch forstner bit, and faucet screen.
Belt sander for rough shaping
Natura oil(NOTE: Do NOT use any other finish but non toxic stuff. Remember you are going to be burning tobbaco in this pipe, so you don't want to burn any other harsh chemicals)
A small drill bit no smaller than 1/8 inch or no larger than 1/4 inch.
Files and rasps for final shaping, and chisels for and detail work.
Japanese saw, or other thin kerf saw.
Clamps and a bench vise
Step 1: Boring the holes: Bowl and stem
What you want to do is to bore your bowl, so that its deep enough to hold the tobacco, but not too deep, as the stem will be connected from the bottom of the bowl.
In the 1st image, we see the forstner bit about to bore the bowl hole. Note how I evenly spaced the hole so that the bowl walls will be even. The second image shows the bowl.
Next, you want to bore the stem hole. The placement of the stem is crucial. If you want to make a fancier stem, you can drill diagonally, but make sure that you leave a small amount around the stem, so that the heat dosnt burn your lips. You don't want to drill the stem hole into the side of the bowl, so make sure you have good control with the drill. You can check the depth of the stem hole by inserting the bit till it hits the end of the hole. Then with your finger, place it in the drill bit and the entrance of the hole. Then move it outside the hole and cross-reference your finger position with the outside. See the diagram for more details.