Print PDF
Favorite
Email
Step 13High temperature cure of the first 3 layers
The prepreg I used must be cured at a high temperature. Normally in aerospace this is done by vacuum bagging the layup and curing in an autoclave or oven at high temperature (typically 120C to 180C).
Since I work in an aerospace R&D department this equipment was readily available and I used it to cure the first three layers.
During cure pressure was applied to the internal tube to prevent collapse of the glass core.
Since I work in an aerospace R&D department this equipment was readily available and I used it to cure the first three layers.
During cure pressure was applied to the internal tube to prevent collapse of the glass core.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
