Introduction: How to Make a Creepy Mask at TechShop

Picture of How to Make a Creepy Mask at TechShop

This is an instructable on how to vacuum form a creepy mask. What you you need:

A TechShop membership
A vacuum former SBU Class
A Piece of acrylic
A mold of yours face, or someone else's creepy mug.
A person to creep on. 


Make sure you Take the Vacum forming class so you know how to use the vacum former! 

Step 1: Step Number One.

Picture of Step Number One.

Place your mold on the vacuum former & lower the bed. 

Step 2: Step Two

Picture of Step Two

Place your acrylic on the vacuum former.

Set your heating zones! You will have to play around with the heating to make sure your material is good to go. 


Step 3: Step 3

Picture of Step 3

Vacuum form that sucker! 


Step 4: Step 4

Picture of Step 4

Pop it out! 


Step 5: Now You Got the Beginnings of a Creepy Mask.

Picture of Now You Got the Beginnings of a Creepy Mask.

Step 6: Cut Out the Mask Part

Picture of Cut Out the Mask Part

Measure your mask and make an illustrator file of an oval where the face is located on your material. 

laser cut that sucker outta there! 


Step 7: Not You Have a Creepy Mask!

Picture of Not You Have a Creepy Mask!

Go decorate and get creepy! 

Comments

NonDisjunction (author)2013-04-07

That creepy mask mold looks awfully similar to the one sitting over by the 3D scanner right now ... Detroit?

Penolopy Bulnick (author)2012-08-29

Awesomely creepy :D

About This Instructable

6,592views

16favorites

License:

Bio: Hatched from a nerd egg.
More by jlburton:Easy Make Bags for Gifts or Craft FairsHow to make a three year old happy @ TechshopHow to cut a dinosaur in half at Techshop.
Add instructable to: