Print PDF
Favorite
Email
Step 4Glue the middle hanging ribbon
To me, this was the trickiest part of the craft. I wanted the hoop half to stick out from the wall, so I had to place the middle hanging ribbon in a way it would support the hoop to be perpendicular to the wall.
Start by putting the end of the middle ribbon through the hanger and then glue that end to the inside of the hoop half. Hang the craft on the wall somewhere (I took down a wall clock to use the nail.) Pull the ribbon until the hoop half is perpendicular to the wall. Go ahead and cut the ribbon, but make sure you leave lots of excess.
Once it is level, use a clothes pin to hold the ribbon in place.
Remove the craft from the wall and while the clothes pin is still in place, glue the ribbon at the top. Once dry, trim the excess.
Start by putting the end of the middle ribbon through the hanger and then glue that end to the inside of the hoop half. Hang the craft on the wall somewhere (I took down a wall clock to use the nail.) Pull the ribbon until the hoop half is perpendicular to the wall. Go ahead and cut the ribbon, but make sure you leave lots of excess.
Once it is level, use a clothes pin to hold the ribbon in place.
Remove the craft from the wall and while the clothes pin is still in place, glue the ribbon at the top. Once dry, trim the excess.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
