It was so cold the glue would instantly solidify when it came out of the hot glue gun.....
Step 1: Materials
For the blaster you'll need a couple of funnels, a few wood dowels, some 1/8" hardboard, a small diameter tube (brass or whatever), a small PVCconnector and a 1x6 wood board as well as a can of black spray paint and some glue- epoxy is best.
For the gun belt you'll need some thin aluminum sheet, some 1/8" hardboard, some rivet style snaps and some brown vinyl.
You'll also need a hot glue gun, a rivet gun and a few wood screws.
Step 2: Clothing
Step 3: Blaster
Now make the scope from a couple of wood dowels and another funnel section an glue a small diameter tube onto the end of the scope. Make the scope bracket from a piece of 1/8" hardboard and a dowel and secure it to the blaster with three screws. Paint it black!
Step 4: Making the belt/holster
Make the belt from vinyl. Now make the belt ends (three of them) from thin aluminum sheet as shown. They are designed to slide over the screws. These get riveted onto the ends of the belt and holster.
To make the holster lay the blaster down and cut the vinyl around it to get the shape right and then glue it together with the hot glue gun. Now rivet on the belt ends. Make a leg strap and a holster strap from vinyl and put snaps on them.
Connect everything together by slipping the belt ends onto the buckles- that's it! There are some pouches that are on the movie belt as well as a "droid caller" but I left those off in the interest of time and cost.