Introduction: How to Make a Ring Out of a Dollar Bill

Picture of How to Make a Ring Out of a Dollar Bill

Its really simple origami and all you need is .......... A DOLLAR!

Step 1: Step One

Picture of Step One

Start by folding the long edges low enough to just barley touch the number 1

Step 2: Step 2

Picture of Step 2

Next fold the paper in half twice and make sure the edge of the 1 is just at the bottem

Step 3: Step 3

Picture of Step 3

Next cross the left end of the paper down from about the middle (i accidentally folded on the right)

Step 4: Step 4

Picture of Step 4

Then just simply fold the end you just crossed up

Step 5: Step Five

Picture of Step Five

Next turn it around so it would look like this

Step 6: Step 6

Picture of Step 6

Next wrap the piece sticking to the right around and under the cross to size it for your finger wrap with finger

Step 7: Step 7

Picture of Step 7

Now  wrap the piece pointing down around the piece you just wrapped it should look like the example above

Step 8: Step 8

Picture of Step 8

Lastly fold the piece sticking out to the right over the piece you just wrapped then fold the white edge sticking out into the gap you made from wrapping the last time if its not going in easily then hold it open with your nails or a key the one should be showing and the final product should look like the example above.
For More go to:


poofrabbit (author)2011-06-07

Fantastic instructions! When I was in middle school we used to make paper rings, but I had long forgotten how! Thanks for the great 'able and the memory jolt!

About This Instructable




More by Luke1999:How to make plastic from milkHow to get a needle through a balloonHow to make a ring out of a dollar bill
Add instructable to: