Introduction: How to Make a Spoon Bait

Picture of How to Make a Spoon Bait

In today's video I will show you a great idea how to make spoon bait


Step 1: Cut Out the Stencil of the Tin, Thin Sheet of Lattin or Copper of 0,2-0,5 Mm.

Picture of Cut Out the Stencil of the Tin, Thin Sheet of Lattin or Copper of 0,2-0,5 Mm.

Step 2: Use a Stencil for That (deepening in the Thick Desk Cut With a Sharpened Knife or a Hacksaw).

Picture of Use a Stencil for That (deepening in the Thick Desk Cut With a Sharpened Knife or a Hacksaw).

Step 3: Such Spoon Bait Has the Following Sizes: Length – 3-8 Cm, Width – 0,8-3 Cm, Disk Thickness – 0,2-0,5 Mm. Fill the Internal Inverted Side of the Spoon Bait With Soldering Flux.

Picture of Such Spoon Bait Has the Following Sizes: Length – 3-8 Cm, Width – 0,8-3 Cm, Disk Thickness – 0,2-0,5 Mm. Fill the Internal Inverted Side of the Spoon Bait With Soldering Flux.

Step 4: the Spoon Baits Are Equipped With Triple or Double Hook Hung on the Ring.

Picture of  the Spoon Baits Are Equipped With Triple or Double Hook Hung on the Ring.

Step 5: How to Make a Spoon Bait!!!!!!

Picture of How to Make a Spoon Bait!!!!!!

Comments

Hook Up TV (author)2016-01-30

Neat!

About This Instructable

788views

15favorites

License:

Bio: https://www.youtube.com/dashboard?o=U
More by romanursuhack:How to Make a Candle in 30 SecondsHow to Make a Mini CANNON With a Screw-bolt / TutorialMega CRAZY Experiment With a Watermelon
Add instructable to: