Introduction: How to Make a Wedding Ring Pillow - I Made It at TechShop Www.techshop.ws
You will need:
White satin fabric
White ribbon
Cotton balls
Step 1:
Take a piece of white satin and cut out two 10 inch by 8 inch sheets.
Step 2:
Pin two pieces of ribbon, each about 8 inches in length (you can trim later if you need), to the middle of one of the sheets of satin.
Step 3:
Sew each ribbon onto the satin sheet. You can you an elaborate stitch: here I used heart stitches. This is where the rings will be displayed.
Step 4:
Pin the two pieces of satin together, the ribbon side in. Sew the two sheets together, leaving a three inch gap open. Make sure that you do not sew over the ribbons! tying them together in the middle will help to prevent this.
Step 5:
Turn the pillow inside out. Stuff the pillow with cotton balls.
Step 6:
Hand sew the three inch gap closed. You now have pillow on which to carry your wedding rings down the isle. Congratulations!