How to make durable plant markers

Do you have some overcrowded clumps of spring blooming bulbs around your garden that you need to dig up and divide? Well now (spring) is not the time to divide them, so what you need is some inexpensive but durable markers to mark the spots. Spring blooming bulbs should be divided during the summer after all the foliage has died back and the bulbs have gone dormant but by then it's difficult to remember where the bulbs are and what type or color they are. So let's make some aluminum plant tags so we'll know where to dig.

Step 1: Tools and Materials

To make these plant markers you will need:

- an aluminum can (A bit thicker metal is better, aluminum step flashing is about perfect.)
- heavy gauge wire. I used aluminum clothes line wire because I had some on hand and that worked great.
- needle-nose pliers
- wire cutters
- a hole punch
- scissors
- fine tipped ball point pen or other engraving stylus

Comments

[alisonb]

I like :)

[kenbob]

this brought to mind a makezine article i had seen on using "dymo" label tool and soda can aluminum - http://makeprojects.com/Project/Soda-Can-Label-Embossing/1921/1

[Mrs Fixit]

I've been looking for this method for the school garden I help with,
should save us a fortune, I always try to re-use whenever possible as part of Eco-schools.
I even have all the tools necessary so no cost outlay.

[THYMETOCHAT]

Nice instructable and a great idea.  I am always searching for a permanent way to mark my plants and your idea is super!   I painted some small wood plaques, put them on dowels and stuck them in the garden, but they only lasted a couple years.  I'll be gathering up some empty cans and hitting the home improvement store for wire!  Thanks!

[SteveGerber]

Thanks!  I've been using these for a couple years now and they do hold up against the elements pretty well.   I think that a slightly thicker gauge of aluminum would be preferable, but I also like the idea of reusing aluminum cans even if they aren't quite as heavy gauge as I'd like.   If you want to try something heavier you might look around for scrap aluminum siding.  It would certainly be heavier gauge but would also be a bit harder to cut.

[megmaine]

Wish I had seen this before I went and bought a bunch of metal, somewhat costly ones, from the garden place. Thanks for sharing, and when I run out of those, I will be trying your idea. This ranks up there with cutting up miniblinds for using as white plastic write-on stakes for pots and such, for recycling and frugality.

[amanda86]

Those look really nice! Do they rust? Thanks:)

[SteveGerber]

No, everything is aluminum which never rusts.

[GorillazMiko]

Nice job, and great job on the photos! They're very clear and nice, what kind of camera do you use? +1 rating.

[SteveGerber]

Thanks for the compliments! I use a Canon Rebel digital SLR. I often use a standard 50mm lens because it has low f stops and can be used in lower light.

[wocket]

What a wonderful idea!