Ever wanted your own starfighter to destroy a giant paper Deathstar? You're in luck!
Step 1: The Base
Make a base by starting with a square piece of paper.
Fold diagonally on each side, then turn the paper over.
Fold in half twice, then turn over again and pull corners together. It should form a diamond shape. If yours is a triangle, you forgot to turn it over!
Step 2: Make a diamond
Lift one fold so that it is pointing upwards, then open and flatten it. Turn the left side of the diamond to the right side and repeat with the next flap. Turn it over and repeat with the other two.
Step 3: The hard part
Find a side where the edge of the paper goes across the point like the end of step one, the open side should point downwards. Fold each side into the middle, then unfold. Lift the edge that runs across to the top, allowing the sides to fold inwards. This should make an elongated diamond shape. If the sides do not meet in the middle, the side corners of your new diamond shape are not at the points you made earlier. If you still can't get it, try folding the top point of the paper down to make a crease in the middle. It will be easier to fold the elongated diamond shape. Repeat on the other 4 sides.
Step 4: The Cockpit
A nice easy step. Fold the top of the diamond down on 3 sides.
Step 5: Erm... Step 5!
You should see four legs at the bottom. Fold each leg halfway, allowing it to turn inside out do that it looks like a mountain from the side. It is easier when you are starting to fold it to the top by pulling it gently sideways and up, then pulling it down. Flatten it. This is similar to making the tail and neck to a paper crane.