Print PDF
Favorite
Email
Step 6Route and solder the wire
Route the wire towards the controller. Use the hot glue gun to fix it every 5 cm or so.
Make sure your wire uses a path that doesn't interfere with the keys functioning.
You might have to cut away some plastic on the inside here and there, to get your wires through.
Then solder the wires to the power points (observe polarity).
With the keyboard open and connected to your computer, do another dry test.
Make sure your wire uses a path that doesn't interfere with the keys functioning.
You might have to cut away some plastic on the inside here and there, to get your wires through.
Then solder the wires to the power points (observe polarity).
With the keyboard open and connected to your computer, do another dry test.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
