With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Taking a Spyderco knife apart is easy, but putting it back together can be a pain. This is the method I came up with after trial and error. I hate to ...
First, take out the five main screws holding it together and the three holding the pocket clip on. All but the hinge are torx T-6; the hinge is T-9. O...
Next, you can lift the blade off and set aside the bronze-phosphor washers above and below it. These are what needs to be cleaned if the knife won't o...
Take the washers one by one, and without touching them pinch them inside a folded piece of paper (1000 grit sandpaper if you have it) and rub them bet...
Once the washers are clean, clean the four surfaces they come into contact with on the blade and metal frame plates. These areas don't usually get ver...
Take the bottom plastic piece, put the screw posts in it and put the bottom plate back on it. If you get the plates confused, the bottom one is the on...
The knife is now more or less assembled, minus the pocket clip and lock-back (all of the remaining screws are of the longer T-6 .25in type). Put the l...
Now that the last screw post is in place, put the that screw in and reattach the pocket clip. You can tighten or loosen the larger hinge screw to make...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »