Print PDF
Favorite
Email
Step 5Setting the rip guide for straight cuts...
If you prefer evenly sized rings, be sure to set and note the width
of your cut. For those planning to make many rings, record the
placement of the rip guide with a permanent marker.
The rip guide is a bar which runs vertically across the saw table.
Most saws come with both inch and centimeter marks.
Slightly unscrew the knob, adjust each side of the rip guide, making
certain they are both the same, tighten knobs.
of your cut. For those planning to make many rings, record the
placement of the rip guide with a permanent marker.
The rip guide is a bar which runs vertically across the saw table.
Most saws come with both inch and centimeter marks.
Slightly unscrew the knob, adjust each side of the rip guide, making
certain they are both the same, tighten knobs.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
