Introduction: Human Powered Snowball Launcher 5-min DIY

Picture of Human Powered Snowball Launcher 5-min DIY

This is a 5-min DIY on how to make a human powered snowball launcher.

Step 1: Things You Need

Picture of Things You Need

You will need a drill or a hammer, nails or screws, box cutter, scissors, jug and a 43 inches tall and 1 inch wide of a stick.

Step 2: Cutting

Picture of Cutting

Make the starting hole, then use your scissors to along the jug.

Step 3: Washing!

Picture of Washing!

Wash out the jug.(you can do this before you cut it )

Step 4: Assembling

Picture of Assembling

Hammer and nail - Use the nail make a hole in the middle of it with the nail, then nail it into the stick as shown

Drill and screw - make a starting hole for the screw, screw in the nail.
(no pictures) 

Step 5: Your All Done!

Picture of Your All Done!

It doesn't look like it but there is a snow ball in there! Snowball Fight!!!!!

Comments

About This Instructable

2,047views

1favorite

Bio: Hunting. Fishing. Survival.
More by Captain MacTavish:Two ways to Set Up Your Fire with Helpful TipsHow to Make a Fire with Wet WoodAltoid Survival kit!
Add instructable to: