Print PDF
Favorite
Email
Step 7Optional Pressure Gauge Assembly
If you want to use the pressure gauge, you will mount that after the main tee. Setup is pretty self explanatory. From top to bottom it goes: Gauge, pipecock, nipple, bushing, tee. Remember to wrap all threaded connections with teflon tape, and make sure you tighten them up well.
Installing this requires cutting the 3/4" x 6" pipe nipple in half, which creates two pieces, threaded on one end and smooth on the other, to go into the bottom arms of the tee. Cement these.
Installing this requires cutting the 3/4" x 6" pipe nipple in half, which creates two pieces, threaded on one end and smooth on the other, to go into the bottom arms of the tee. Cement these.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
