Print PDF
Favorite
Email
Step 3Construction
1. Drill holes to mount components.
2. Prepare space for element if necessary.
3. If the enclosure is solid holes will have to be drilled to allow air to hit the diaphram of the mic. Or a large hole can be cut and covered with a protective mesh or screen or screens. The mesh from a kitchen or tea strainer would work. If the enclosure is open on the element end it will need to be capped off to protect the mic.
3. Mount jack & pot.
4. Mount Element. It needs to be secure so if the cavity is larger than element it will need to be held in place. It can be encase in a styrofoam piece the fits tight in the enclosure or use bubble wrap etc. ALso it can be glued, epoxied, taped, etc.
5. Close everything up and make sure all is well.
2. Prepare space for element if necessary.
3. If the enclosure is solid holes will have to be drilled to allow air to hit the diaphram of the mic. Or a large hole can be cut and covered with a protective mesh or screen or screens. The mesh from a kitchen or tea strainer would work. If the enclosure is open on the element end it will need to be capped off to protect the mic.
3. Mount jack & pot.
4. Mount Element. It needs to be secure so if the cavity is larger than element it will need to be held in place. It can be encase in a styrofoam piece the fits tight in the enclosure or use bubble wrap etc. ALso it can be glued, epoxied, taped, etc.
5. Close everything up and make sure all is well.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Oct 22, 2008. 2:08 PMpod
says:
what typ of lotion bottle did you use?????
Reply
 |
Add Comment
|
