Print PDF
Favorite
Email
Step 6Glue the Lens and O-ring
Drop the lens into the bezel and make sure there aren't any little tabs or standoffs preventing the lens from seating into it for gluing.
Apply a VERY small amount of glue and place the lens in the bezel with tweezers. Too much glue will create a haze on the lens and get all over the place. If you are at all worried about hazing the lens, use an industrial white glue or RTV. Allow time for it to cure before proceeding.
Find an o-ring that will fit into the back of the bezel and around the lens. This will help hold the lens in place when on the phone.
Glue the o-ring in place. Use super glue or RTV. RTV will take a couple hours to cure, at least.
Apply a VERY small amount of glue and place the lens in the bezel with tweezers. Too much glue will create a haze on the lens and get all over the place. If you are at all worried about hazing the lens, use an industrial white glue or RTV. Allow time for it to cure before proceeding.
Find an o-ring that will fit into the back of the bezel and around the lens. This will help hold the lens in place when on the phone.
Glue the o-ring in place. Use super glue or RTV. RTV will take a couple hours to cure, at least.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
