Print PDF
Favorite
Email
Step 7Finish Bending the Wire
Fit the bent wire on the phone and make where the arms pass the lens on the phone. You will want to make 90 degree bends here and then trim the wire.
Bend the wire as shown in the photo and clip. Leave about 1/8" after the bend.
Trim off a bit of the heat shrink and shrink a little band around the cut end.
Bend the wire as shown in the photo and clip. Leave about 1/8" after the bend.
Trim off a bit of the heat shrink and shrink a little band around the cut end.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
