Introduction: IPhone Amplifier Made of Cheap Materials

You want to increase the volume of iPhone music? Do not want to buy expensive speakers? You are on a camping trip or in the office and want to listen to music?
Here you will find the answer!

Step 1: Step One

What materials are needed?
IPhone
Knife
2 cups Styrofoam / plastic / paper
Plastic bottle / can
Insulating tape

Step 2: Step Two

Take the cups and with the knife cut the bottoms out

Step 3: Step Three

Cut the plastic bottle into 3 parts.
We will use the middle part that look like a tube.

Step 4: Step Four

We will take the middle part of the bottle (the tube) and by using a knife we shall cut a thin slot just in the dimensions of the iPhone.
The slot shall measure approximately 1.5X6 centimeters

Step 5: Step Five

At last - we neet to connect the cups (Those without bottom) to part of the bottle (that we cut).
The parts will be attached with insulating tape.

Step 6: The End

We will put the iPhone with the speaker side (bottom side) into the opening in the facility.
We activate the music - and what's left is to enjoy :)

Comments

author
国王的房东 made it! (author)2013-02-22

really cool and green. i will do it right now

author
cattibalistic made it! (author)2012-10-09

I'm going to try this with my ipod! I'll see how it works!

author
cattibalistic made it! (author)cattibalistic2012-10-09

It didn't do much... But it still worked a little.

author
CarolinaHunrichse made it! (author)2012-10-08

i like it

author
rimar2000 made it! (author)2012-10-07

Clever!

Really this is not an amplifier, but surely works as if it were, that's what matters...

About This Instructable

3,127views

28favorites

License:

More by ornevo:Decorated dessert - Santa Claus made ​​from strawberries and whipped creamDecorated dessert -  Rudolph the reindeer MuffinsDecorated dessert - marshmallow snowmen
Add instructable to: