Introduction: IRON MAN Concept RFID Door Access

Picture of IRON MAN Concept RFID Door Access

This time we will make IRON MAN concept RFID Door Access Gadget

Step 1: Requirements

Picture of Requirements

To make this Easy & Cool Gadget. you require an RFID card & a Hand glove.

Cut the RFID Card as per the requirement (NOTE: Take care that the coil & chip inside the RFID card is not damaged.

Cut the Hand glove as shown above in the picture. Decide the area where you need to fix the RFID Card & paste it using a Quick fix glue.

***You are Done***

Step 2:

Comments

Neander (author)2016-07-27

Unfinished...

ksashikumar (author)Neander2016-07-27

Ya... Later you need to register the RFID to the door access control device

About This Instructable

774views

14favorites

License:

More by ksashikumar:IRON MAN Concept RFID Door AccessWearable Pendrive Waterproof Networking Tool Kit
Add instructable to: