In this article I am going to demonstrate image acquisition tool in matlab.

imaqtool(file) starts the tool and then immediately reads an Image Acquisition Tool configuration file, where file is the name of an IAT-file that you previously saved.

Step 1: Command Used

Command used is : imaqtool

imaqtool launches an interactive GUI to allow you to explore, configure, and acquire data from your installed and supported image acquisition devices.

Step 2: GUI Formed

Step 3: GUI Features

image acquired can be further processed

for more quires you can visit our site:


About This Instructable



More by Dcube Tech Ventures:Home Automation with Raspberry Pi using Relay board Motion Control with Raspberry Pi and LIS3DHTR, 3-Axis Accelerometer, using Python 3-Axis Accelerometer, ADXL345 with Raspberry Pi using Python 
Add instructable to: