The victim was a $8 USB Bluetooth dongle, with a usable range of about 10 metres (less through walls).
Being a radio ham, I am familiar with antennas, and know how critical it is to get the CORRECT antenna length, if your signal is going to be efficient.
I was surprised to find other 'range extender' mods on the net, which did not mention this important fact! (One site had someone who had attached a "foot long piece of wire" onto his USB dongle and was wondering why it didn't work very well!!!)
There is a recognised formula for calculating antenna length/frequency, which is (without going into detail) 300/frequency - i.e. 300/150(MHz) will give you 2 metres.
As Bluetooth devices work at frequencies of around 2450MHz, the formula will give you an antenna length of +/- 12cm.
This figure then has to be divided by 4 to give us a quarter wave antenna, which will be 30mm in length - THIS LENGTH IS CRITICAL!!!
25mm or 35mm will just make it less efficient (Lower range).
Your old CB antenna WILL NOT WORK!
So - if you are happy to try something (at your own risk), and want to get a significant increase in usable range for you dongle, go to the next step, but remember, the end result doesn't look pretty, but performs brilliantly!
Step 1: Opening up the USB Bluetooth device
The picture shows the dongle with the 'antenna' on the side removed.
Don't worry, this antenna is just a plastic dummy, and performs no function at all!
The plastic case then has to be prised open, using either a flat blade screwdriver, or a blunt knife.
There are no screws.