Infamous 2 Amp

Step 2: The Base

first off you're going to want to cut two equal sections of 1/2" pvc at about 18" long
then you need to cut the 3/4" pvc to be 15"

NEXT

add a 4-WAY COUPLER at the end of the 3/4" pvc

afterwards you are going to need 2 3/4" 90 degree couplers with spigots
-dremel out the insides of the spigots so the 1/2" pvc fits nice and snugly inside
- cut 3 sections of 3/4" pvc about 1" per section
- insert these sections into the remaining openings of the 4 way coupler
- insert a 90 degree coupler on the left side, and glue it into place
DO NOT GLUE BOTH COUPLERS ON!

take any 3/4" coupler and saw off about half an inch from one of the ends, then slide that piece about half way across the 3/4" pvc section

at the other end of the 3/4" pvc you should glue on a rubber cap, mine was a little fancier than most rubber caps which is good.

Finally you take a little light fixture piece and you glue it onto the top 3/4" pvc coming out of the 4-way coupler (this piece can easily be changed to whatever you find lying around the house

Comments

[TheInventor1997]

i have the figure and it looks like the diameter of the handle is twice as wide as the prongs, it looks really thick!, great instructable BTW. this is an instructable i'm doing, maybe with METAL ;) pvc first though.