Infrared (IR) Webcam

Step 2 Remove PCB and lens enclosure

Remove the PCB (the main chip) and the lens enclosure. Since this is basically the whole of the insides in most cases, you need to remove all the casing. When handling the PCB (usually green), try not to touch it too much, and attempt to handle it by the edges. The same goes for the lens.

You should end up with something like the one shown in the pictures.

Comments

[kgraebner]

lol i just threw my infared light filter for my 35mm film camera over my webcam xD got some neat pics during the day, but if theres no sunlight in my room or anythin all i can see is the flash of the infared led off of my remotes xD