Introduction: Make It - Engraved Cutting Board

Picture of Make It - Engraved Cutting Board

Epoxy filled, CNC cut inlay in a maple cutting board. The epoxy used was West Epoxy and it was poured over fully cured black spray paint. Before the black paint was laid down, I sealed the wood with a spray lacquer. The top was was sanded from 80 up to 400 before a mineral oil and beeswax finish was applied.

Comments

DIY Hacks and How Tos (author)2015-06-28

Nice cutting board design.

About This Instructable

726views

17favorites

License:

Bio: https://www.youtube.com/dustinpenner1
More by dpmakestuff:Nightstand w/ Easy Secret CompartmentMid Century Modern DeskTurning Firewood Into a Cup
Add instructable to: