Introduction: Installation for DoArm S6

Picture of Installation for DoArm S6

This manual is just used for the

installation of stainless steel DoArm S6, which is development by Shenzhen Doctors of Intelligence & Technology (Doit, Other similar manuals, please visit the related documents under the same catalog. Note, since the edges maybe sharp, please be careful when installing in case of protecting the fingers.

Order link: DoArm S6. More details, and the newest information, please visit our official bbs site.

Step 1: Installation for the Base Part

Picture of Installation for the Base Part

Step 2: ForeArm

Picture of ForeArm

Step 3: Wrist

Picture of Wrist

Step 4: Upper Arm

Picture of Upper Arm

Step 5:

Picture of

Step 6:

Picture of


LucianoL24 (author)2016-12-24

thanks, good work, did you have some libraries for this arm?

About This Instructable




Bio: Specializing in the OpenSource Hardware. skype: yichone
More by yichone:Make a Wireless Bluetooth/WiFi Robot Tank Car Chassis Based on ESP8266 and HC-06Mobile Robot Arm DoArm S7 by wifi Arduino uno r3Installation for DoArm S6
Add instructable to: