Here is a video of my final table in action in the dark, and a photo of what it looks like:
Step 1: Choose your size, and Design a Table
I choose the 6 panel kit, and this instructable will focus on that size. If you choose the 8 panel kit, you can still use this guide, just remember to change the measurements to your own.
Next make a rough sketch of how you want your table to look.
If you are good with Google Sketchup, I suggest you use that to get some nice 3-D views of it.
Step 2: Buy the lumber
I choose regular 1x4 pieces of pine for the legs, and 1x3 pieces for the tray to hold the LEDs.
Step 3: Put the legs together
I'm doubling up the wood so that it looks better, that requires lots of cuts, and screws. Pre-drill the holes, and counter-sink the screws so that you don't see them.
Step 4: Fill in the holes
I also used ran a router with a 1/4 inch half circle bit around the edges to smooth them off, and make them look nicer.
Then sand it, and repeat it until it is smooth enough for you (it is after all, your table).