Introduction: Interfacing TSOP1740 With Mediatek LinkIt One

Picture of Interfacing TSOP1740 With Mediatek LinkIt One

In this Instructables You will be able to interface TSOP 1740 with Mediatek LinkIt One Board.

TSOP 1740 is a Photo Sensor which detects 38Khz frequency which is emitted by remote controllers of TV, Music System,etc.

Step 1: Requirements

Picture of Requirements

  • Mediatek LinkIt One Board
  • TSOP1740 Photo Sensor
  • BreadBoard
  • Jumper wires

Step 2: Connections

Picture of Connections

TSOP1740 :Photo sensor

VCC(+5v): 5V On Board

Ground:GND

Out Pin: Pin D8

Step 3: Code,Compile and Run

Picture of Code,Compile and Run

I have uploaded the code to interface the photosensor.

Congratulations!!You are ready to Go!!!

Open Serial Monitor To See the Output.

Comments

DIY Hacks and How Tos (author)2015-12-10

I love these IR receiver modules, they let you control just about anything with IR remotes.

About This Instructable

271views

6favorites

License:

More by VaibhavK18:Entry controlled Parking System Using Servo Motor and PIR with LinkIt One Board Colour Detection Using TCS3200 Colour Sensor and LinkIt One BoardProgrammable Robot Car using Mediatek LinkIt One board and L293D Motor Driver IC
Add instructable to: