Print PDF
Favorite
Email
Step 7Finishing touches on the board
A couple last things.
First, we need to wire in the power switch. Strip and tin both ends of the 2 conductor ribbon cable. Push the two wires through the back side of the board and solder on the front side. Once final the board is fitted into the case, the other end of these wires will be soldered to the power switch.
Now, install the battery holder. Make sure the positive terminal of the battery holder is in the correct position. Flip the board over and solder the pins into place.
First, we need to wire in the power switch. Strip and tin both ends of the 2 conductor ribbon cable. Push the two wires through the back side of the board and solder on the front side. Once final the board is fitted into the case, the other end of these wires will be soldered to the power switch.
Now, install the battery holder. Make sure the positive terminal of the battery holder is in the correct position. Flip the board over and solder the pins into place.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
