Introduction: How to Make a Tripod Adapter for Iphone or Phone

this is an idea I had for my phone because I like to take pictures and videos. I have a little show on Youtube, and the camera I used broke, so I had to take a hiatus. I went on the Internet, and looked for an adaptor and it cost about $20. so then I thought of making an adaptor myself. it is made of thick poster board, Velcro, and a hard case for a phone. altogether it cost about $5-10 depending on the products you used.


Step 1: Supplies

Supplies you will need:
    Hard Case
    Scissors
    Ruler
    Pen
    Box Cutter or Blade
    Velcro
    Case for Phone (preferrably hard case)
    Poster Board (1/2 cm thick)
    Tripod

Step 2: The Real Step 1

first off, take your poster board and ruler and measure 4cm x 4 1/2cm. Use the ruler to straighten the sides. After that, cut the shape out.

Step 3: Step 2

next, take the velcro and put either part of it on top of the shape. make sure to press down on the velcro to make sure it is on good.

Step 4: Step 3

Next, take your case and find the back of it. you want to put the other part of the velcro on the back of the case. Again make sure too press on the velcro to make sure it is on good and doesnt fall or peel off. 

Step 5: Step 4

now take the case and the shape and put them together. it should look something like the picture

Step 6: Step 5

Now take the Case and put it in/on the tripod. should fit in side ways snug and not loose. the lense should be visible.

Step 7: Notes

if it droops a bit, tilt the base.

any questions, send me a message.

this is my first instructable, so if something you think is left out, tell me

it can also be used as a stand!

Comments

author
nevssons (author)2010-12-19

IPhone or phone? So IPhone is not a phone? Well... I agree

About This Instructable

9,598views

1favorite

License:

More by personguy31:How to make a tripod adapter for iphone or phone
Add instructable to: