JONNY POPPER

Published

Introduction: JONNY POPPER

WHAT YOU WILL NEED....
1.BOTTLE(SMALL)
2.RUBBER GLOVE(WASHING UP GLOVES)
3.SCISSORS.

Step 1: CUT THE BOTTLE

cut the bottle at the top whair the cap is
make sure it is a smoth cut ont jagged.
you should throw away the left over bottom bit away!!!!
you wont be needing it.

Step 2: TAKE THE GLOVE....

take the glove and snip the longest finger off.
throw away the hand keep the finger.

Step 3: Put the ......

this is my first instructables so it is hard to explain.....
pull the plastic ring that is on the threads off....it may take a few seconds

Step 4: Then....

then once you have done that you should have a bottle with no lid(take the lid off)and no ring.
put the rubber glove finger on the lid bit,wheir the lid and ring went.

Step 5: Pull....

pull the blue(as shown on previous instruction)ring down over the yellow finger(glove finger)it should go down- hard to pull back out KEEP IT LIKE THAT that is you made a "jonny popper"

I AM NOT RESPONSIBLE FOR ANY DEATHS OR ACCIDENTS BY THIS INSTRUCTABLE!!!

VERY VERY DANGEROUS

Share

    Recommendations

    • Oil Contest

      Oil Contest
    • Casting Contest

      Casting Contest
    • Stick It! Contest

      Stick It! Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    8 Comments

    Irn-Bru, good choice :)

    whats it do?

    these things are great my m8 tanned a phone box with one of these when we were kids

    ARE YOU FROM ENGLAND OR SOME THING?NEVER MIND,SERIOUSLY THOUGH HOW DO YOU USE THIS THING? WHAT DOES IT DO?

    it can shoot lots of things give us a call if you want more info ,small stones ,peas etc

    ok thanks i use small knex pieces they really really really hert

    you are not the first one to do this... reasearch before posting an instructable.