Introduction: Jabba's Knex Rifle ( Edit )
THIS IS NOT A BRILLIANT INSTRUCTABLE -- I ONLY POSTED THIS BECUSE I HAD THESE PICTURES , THE GUN IS NOW DIS-MANTLED AND NO MORE PICTURES WILL BE POSTED -- MAKE DO WITH THIS!!!!!!!
My rifle from the slideshow , i was going to murder this so i thaught posting it first might be a good idea!
BEWARE -- CUT PEICES NEEDED you MUST have at least 3 cut greys/oranges for the hopper and 2 sawnoff whites
lets get started then?!?
By the way - i have a modded version of Louis XIV 's G3 SAS that if prompted i might post PROPER STEP BY STEP instructions of... pics at the end of the i'ble
Step 1: Random Bits and Bobs
not much to say except that the crappy bi-pod is TOTALLY optional , as with the scope
Step 2: Stock
VERY SIMPLE , two layers held together by oranges and blues and yellows where specified
Step 3: Fake Barrel
VERY EASY -- again , as with the stock 2 layers held together by oranges,blues and yellows where i say!
Step 4: Handle
By far the easiest part of the gun .... its allmost TOO simple
Step 5: Main Section Walls ( Step by Step )
Right - enough of my CBA attitude - this is where i actually have to take some proper ' instructable ' pictures : (
pic 1 - build theese
pic 2 - bulild ( trigger )
pic 3 - diferent veiw
pic 4 - attach trigger to ONE of the sides you built earlier ( one with the oranges and stuff )
pic 5 - build theese!
pic 6 - begin construction! - ie - part from pic 4 plus part from pic 5
pic 7- Both sides done!
Step 6: Main Section Innards
This peice was HELL to build so ive only posted a few pics - ie. not taken apart , but i think you could build it from theese!
Step 7: Building the Main Section
Pic 1 - place your ' innards ' onto one of the sides from step 5
Pic 2 - connection point !
Pic 3 - connection point !
Pic 4 - VERY IMPORTANT
Pic 5 - add other wall
Pic 6 - add mag pusher
Pic 7 - mag elastics
Step 8: CONSTRUCTION
Pic 1 - Attach main section to handle
Pic 2 - Attach main section to fake barrel
Pic 3 - what it should look like ( barrel plus main section ) and trigger elastics
Pic 4 - Attach Fail-pod
Pic 5 - Attach stock
Pic 6 - Ram placement
Pic 7 - 11 - Grenade laucher pictures -- no instructions but if you can u build from the pics yaknoo : )
Anything onwards from picture 11 -- Finished product
Step 9: G3 SAS
If you want proper step by step instructions let me know!