Introduction: Jamesdude's Oodammo Pistol

Picture of Jamesdude's Oodammo Pistol

This is an oodammo pistol I made when I saw the Mezak. Most of the oodammo guns I made were white rod thick guns, but when I saw the mezak, "Meh, what the heck, why don't I build blue rod thick guns?" So I did...

Stats:
30-40 ft w/ 1 #64
Very sturdy
Powerful.
Tilting mag
Shoots oodammo


Step 1: Body/Trigger

Picture of Body/Trigger

Follow the pics.

1. Make these.
2. Connect them the way I did.
3. Insides.
4. Another pic of insides.
5. Put the last two layers on.

Step 2: Mag

Picture of Mag

Here's my flip-mag.

1. Make these.
2. Connect them.

Step 3: Handle

Picture of Handle

Follow the pics.

1. Make these.
2. Connect them.


Step 4: Assembly

Picture of Assembly

Follow the pics.

1. Connect handle.
2. Connect mag.

Step 5: Other Bits

Picture of Other Bits

Other bits.

1. Make these.
2. Put them in the gun.

Step 6: Rubberbands

Picture of Rubberbands

Here's the rubberbands.

Step 7: Done!

Picture of Done!

DOOONNNEEEEE!!!!!!!!!!!! YOU GET A COOKIE!!!!!!!!!!!!!!! YAAAAAAAAAAAAAYYYYYYYYYYY!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Comments

~Aeronous~ (author)2010-06-03

 Very good. The trigger is better then Mezak, but the trigger is weak because it goes through the whole handle. Maybe try fixing that.

~KGB~ (author)2010-06-02

not bad, improve the handle a bit...

jamesdude (author)~KGB~2010-06-02

Will you rate?

~KGB~ (author)jamesdude2010-06-02

yup 4*

About This Instructable

548views

2favorites

License:

Bio: I am a knexer. HAPPY NOW?
More by jamesdude:Knex pistol: Contest entryJamesdude's Oodammo PistolModified ZLG
Add instructable to: