Print PDF
Favorite
Email
Step 6Finishing
For stability, I usually glue one of the hard drive platters to the bottom. Makes a nice base. I also place a drop of glue on the connection point between the leaves and the stem, as well as the screw holding the stem on the base. This will keep them from loosening up over time.
I have also attached bugs made from IC chips to small wires and attached them to the base. the ready made mounting points have all kinds of possibilities.
Different hardware will have different configurations inside, so if you make a few of these, they are almost certain to be unique one-of-a-kinds.
For more ideas, check my gallery here: http://photozz.deviantart.com/
I have also attached bugs made from IC chips to small wires and attached them to the base. the ready made mounting points have all kinds of possibilities.
Different hardware will have different configurations inside, so if you make a few of these, they are almost certain to be unique one-of-a-kinds.
For more ideas, check my gallery here: http://photozz.deviantart.com/
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Feb 14, 2010. 5:15 AMvadios
says:
Very interesting and beautiful way of using PC utility!
Reply
 |
Add Comment
|
