With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
During a recent craft store visit to Michaels, I came upon an amazing discovery...giant diecut 12x12 scrapbook pages in laser cut numbers, letters, and mod designs. It was ...
Before you begin: Wash fabric to remove sizing. Also, prepare your work area for spraying. Use a large table or outdoor area. Using fabric marking pencil, trace around ...
Cut around traced lines with scissors.
Lay diecut on top of fabric.
Using Fabric Spray Paints, spritz and spray over top of diecut as desired. The more you spray, the darker the areas will become. Pressing pump halfway will produce ...
Your finished design will look something like this. Spray on fabric as desired. For best results, let fabric sit for 72 hours before you wash it. I personally ...
7. Iron both pieces of fabric Next, flip the two pieces inside out and pin together around edges.
Sew around edge of pillow. I used a zigzag stitch, but it may have been better to do a straight stitch.
Leave an opening of about 2 inches. Now turn the pillow right side out.
Stuff the pillow using fiber fill and shape as you go.
Using needle and thread sew up opening and you are finished!
Here's the other side of the pillow. It has a more concentrated spray look. Also I laid the diecut down again and sprayed and it created a slightly ...
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.