With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Back in mid November of '07 I was itching to try out at making a rubber band gun out of K'NEX, but I was disappointed with the performance of the desi...
The receiver contains the wheel, spacers and trigger sandwiched together. Create two of these side pieces.
The two sides are initially held together by three blue rods. From there we add connectors for support. 1. Add the first rod on the yellow connector ...
With the rods in place, we can add three yellow connectors that act as spacers. 1. On the lowest rod, insert a yellow rod. Three yellow connectors wi...
Just like the last step, we are adding more connectors that act as spacers. These spacers not only offer stability, but keep the trigger locked in a r...
These next two connectors are used to lock the trigger in place. This is a nice feature for such a creation; however, this step is option.1. A green c...
Now to add the actual trigger and spacers. These spacer make sure the trigger moves smoothly.
1. Start by hold the pin you made in one hand, but leave one side of the pin (blue spacer piece and connector) off to slide it through the white conne...
Just as before, you will need to make another pin to hold up those spacers you've just added. This pin goes through the top holes securing the spacers...
Now for that one vital piece, the toothed wheel. This is where all the rubber bands will be loaded on to. Like previous steps, this involves creating ...
All that is left is to add a small rubber band to the trigger to make the whole thing operate properly. First. Try and find a rubber band slightly la...
With the rubber band, loop it around so that it is attatched to both ends of the blue peg under the trigger.
Lastly, you must take one side of the looped rubber band and bring it up to a part of the trigger within the frame. As you can see. The rubber band m...
As Of: 6.19.08These Instructables are being updated to feature instructions for creating the featured barrel and quick stock used for this rubber band...
It is important to match the rubber bands to the length of barrel you make to insure smooth operation.I recommend rubber bands that are slightly wide(...
Firing is as simple as pulling the trigger! I hope everyone enjoys this design, and always always ALWAYS be careful and excercise caution when using r...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »