This is an easy 20min build Knex Gun, with a lot of power and an easy locking method*. It is very compact but still packs a nasty amount of strength! It is not a toy.
You'll need the pieces shown in the picture as well as 3 'standard' elastic bands or some reasonable equivalent. If the gun snaps often you can superglue the parts on. So let's get started!
*The trigger should fall down due to the elastic bands.
Connectors
13 grey
1 yellow
1 'hubcap' brown
2 red
3 orange
1 black joint
2 light grey
2 black 'square' joiners
Rods
4 white
2 red
1 blue
Spacers
6 blue (4 when using revised version)
If in doubt all will become clear in the following pictures.
You'll need the pieces shown in the picture as well as 3 'standard' elastic bands or some reasonable equivalent. If the gun snaps often you can superglue the parts on. So let's get started!
*The trigger should fall down due to the elastic bands.
Connectors
13 grey
1 yellow
1 'hubcap' brown
2 red
3 orange
1 black joint
2 light grey
2 black 'square' joiners
Rods
4 white
2 red
1 blue
Spacers
6 blue (4 when using revised version)
If in doubt all will become clear in the following pictures.
Remove these ads by
Signing Up
Visit Our Store »
Go Pro Today »
Also, even though I hadn't posted it on the internet, I was using oodammo sometime in october 2006.