Introduction: Keep Your Da Vinci Tools Where You Can Find Them

You will need:

Stick magnets on the inside of the Da Vinci case to hold the scraper and extruder cleaner. A magnet attached to the wire brush will hold it in place. The brush that came with my printer has a convenient slot in the handle, into which I simply glued a magnet. Voila! No more scratching to find the tool.

Comments

About This Instructable

451views

1favorite

License:

Bio: Pioneer of embedded microprocessors. Retired electronics engineer and company owner.
More by SPLatManOz:Keep your Da Vinci tools where you can find themMeasuring and mixing small amounts of materialsMatching 3D printed part to RC servo horn
Add instructable to: