Step 1: Materials Required
2. Pencil / Marker
4. Scissors / Craft Knife
5. Binding Wire
7. Loads of Creativity and Imagination
Step 2: Start with a coffee cup
Mark margin of 2cm on each side (length wise)of the cup. This provisions a locking system for the bracelet.
Step 3: Continue...........
Every alternate block of the arch has to be cut off without cutting the margin.
Step 4: Continue.......
When the bracelet is worn, this binding wire can be interlocked to hold the overlapping margins together. You can also paste an additional layer of paper cup to the layer where the binding wire is fixed, for extra support .
Step 5: The final step
The bracelet can be embellished with accessories like beads, shells, decorative threads, rivet, paint, the list is endless and is only limited to your imagination.
However, for illustration I've only used a Nylon Ribbon in simple criss cross.