Introduction: Kierans Corner: Build a Leather Yu-Gi-Oh Card Deck Holder in Under 2 Hours
In this project I am going to show how to build a card holder in under 2 hours with help from my little brother and my dad.
Step 1: I Need a Card Holder for My Yu-Gi-Oh Deck!
I do not have a deck holder, I need to build one.
I found this book and we should make this.
It is simple to make, lets do this!
Step 2: Draw Out Your Plan
First get paper and pencil and draw out your pattern, make sure you have an eraser because mistakes happen. Make sure you use a pencil that has an eraser, we had to use two pencils because the first one was sharpened with no eraser and so we used a second pencil that was missing its lead but had a good eraser on it.
Next cut out your pattern
Next fold your pattern to see if it works, this may take a few tries to get it right.
Step 3: Workshop Time, Make Sure You Have Supervision!
Go to your workshop
Find some leather
Put the pattern on the leather
Trace your pattern
Cut it out
Punch holes for sewing
I used a used a groove cutter to help with the bends.
Step 4: Putting Your Project Together
Sew your leather with a blunt needle so you dont stick yourself.
Decide how you want to close your deck holder, I chose to use a box clasp
Be careful not to hit your fingers when you hammer rivets, and we are done!
Total build time with my brother helping took forever, a whole 2 hours!
Stay tuned for more of Kierans Corner and my brother site Torins Tutorials
Step 5: Because Clone Trooper Armor!
We have a be nice policy.
Please be positive and constructive.