Print PDF
Favorite
Email
Step 5Putting it all together
Pin the completed circuit to the inside of the hat, matching it up with the teeth in the brim. The LEDs will poke out and be slightly difficult.
Using a water- or air-soluble pen, draw a bunny face onto the hat, with eyes over the LEDs and nose over the battery. Backstitch along these lines with nonconductive thread, and rinse off the markings (use a finger dipped in water, no dunking!)
From the inside of the hat, stuff the cheeks and nose very gently. This gives the whole thing a bit of relief and distracts from the poky LEDs.
Finally, cut a small triangle of pink felt and sew (or hot glue, if you're in a hurry) it on.
Put on the hat. Now push the nose! Go on, push it!
(I promise to post a picture of the parents & baby in these hats, as soon as they send it to me. But it will be a couple weeks still...)
Using a water- or air-soluble pen, draw a bunny face onto the hat, with eyes over the LEDs and nose over the battery. Backstitch along these lines with nonconductive thread, and rinse off the markings (use a finger dipped in water, no dunking!)
From the inside of the hat, stuff the cheeks and nose very gently. This gives the whole thing a bit of relief and distracts from the poky LEDs.
Finally, cut a small triangle of pink felt and sew (or hot glue, if you're in a hurry) it on.
Put on the hat. Now push the nose! Go on, push it!
(I promise to post a picture of the parents & baby in these hats, as soon as they send it to me. But it will be a couple weeks still...)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
