Introduction: K'nex Ball Machine Legacy Update

Hi everyone! This what I have done on my second K'nex ball machine, which is called Legacy. Unfortunately, I was unable to fully finish it in time for the contest. So, I decided to make this to show you guys what I've done so far. Legacy currently has four functioning paths, three lifts, and one new element, the Cross-V Funnel. (It's in the sixth picture.) The video shows two of the paths, both which connect to the Cross-V Funnel. The video also showcases what the machine looks like and some of it's current bugs. If you like Legacy so far, why not vote for it in the Toy Rods And Connectors contest? I would greatly appreciate it if you did. Check back soon to see the finished version of Legacy! See you all next time.

-Knex2thelimit

Comments

author
Knexmaster888 (author)2014-08-15

Nice job, looks better than mine, if not, check out discombobulating, also, I voted for you

author
Sorunome (author)2014-08-12

Looking quite sweat! :D

author
Knex2thelimit (author)Sorunome2014-08-12

Thanks! Also, it's supposed to be spelled "sweet." You just spelled "sweat". :D (It's no big deal.)

author
Sorunome (author)Knex2thelimit2014-08-12

Seems like i spelled it wrong all the time then :P

author
Knex2thelimit (author)Sorunome2014-08-13

Lol. :p Don't forget to vote for Legacy in the contest!

author
sandroknexmaster (author)2014-08-12

Looks good so far!

author

Thank you! Don't forget to vote if it gets accepted in the contest. :)

author

I will :)

author
sathothy (author)2014-08-12

Looks very good! Too bad you couldn't finish it in time.

author
Knex2thelimit (author)sathothy2014-08-12

Thanks! Yeah, I was disappointed about that too.

About This Instructable

441views

3favorites

License:

Bio: Hello there! I'm Knex2thelimit. I build all sorts of things with K'nex, from practical items to ball machines. Sometimes, I've even made ... More »
More by Knex2thelimit:A Monument to Joel Glickman: the Founder of K'nexBuild A K'nex Bird Feeder!Project A.F.F: A K'nex Ball Machine
Add instructable to: