Introduction: Knex Book Ends
Knex Book Ends.
These are some book ends I made when I realised that I had my CHERUB collection were on my shelf and they were just stacked up and looked a little untidy. So, you know what I did? Made some KNEX BOOK ENDS! WOO! :-P
EDIT: This reacher 4.08* :-)
Just a warning: This project uses 26 Y-clips :(
Back onto the subject... I hope you like this! Please rate, comment and subscribe. Thanks!
Step 1: Base- Part 1
The is the first part of the base. Then next step it how to put it together.
Follow the notes on the pictures.
Step 2: Base- Part 2
This is assembling the parts for the base you made in the previous step.
Follow the notes on the pictures.
Step 3: Stand- Part 1
This is the stand. The bit that touches the books.
Follow the notes on the pictures.
Step 4: Stand- Part 2
This is the assembly of the parts of the stand you made in the previous step.
Follow the notes on the pictures.
Step 5: Connecting the Base to the Stand
This is how to connect the base to the stand.
Follow the notes on the pictures!
Step 6: Cloning
*Sigh* Guess what.... You have to do steps 1-5 again to make the second book end! *Sigh* Lol.
Anyway, reapeat steps 1-5 again and you are finished, or just make the exact same as the other book end you just made!
Step 7: Finished!
Congratulations! You have finished making your book ends. Happy reading!
Please rate comment, subscribe, and tell me what you think!
Thanks!