Introduction: Knex Bow by AzNaLaNo

Picture of Knex Bow by AzNaLaNo

My own creation of a knex bow

Takes about 40 - 55 pieces

Pros:
Smoothe
Simple
Goes about 20 feet or more depending on RB

Cons:
Doesnt shoot as far

Step 1: Center

Picture of Center

Make one of this, its where you put your ammo in.

This one is simple

5 Purples

2 Blue Spacers

2 Blue Rods

1) View One

2) View Two

Step 2: Body Parts

Picture of Body Parts

Body

Easy again, make for of them

Make four of them

One Blue Rod x4

Three White Rods x4

Two Green Rods x4

One White Snowflake x4

Two Grey/Silver Piece x4

One Yellow/ Half Piece x4

One Green Piece x4

1) Make the first one

2) Then make 3 more

Step 3: Other Pieces Needed

Picture of Other Pieces Needed

1

Two Reds Pieces

Four White Sticks

2

Four White Sticks

Eight Spacers


1) Reds

2) Red with White Rods

3) White Rods

4) White Rods with Blue Spacers

Step 4: Connect! Then Add

Picture of Connect! Then Add

Easy!

Connect

Add Reds

Whites with Spacers ( a bit hard )

Step 5: Wheels + Rubberbands + Ammo

Picture of Wheels + Rubberbands + Ammo

Add small wheels
with White rod in middle

Put Rubber bands in the slot

Stretch and Put on greens

Ammo Grays

How to use stick the Gray rod on the hole here the blue spacers are

Line up with rubber band

pull back

release
and let it fly


Step 6: DAMAGES WITH PIN TACK THING Lol

Picture of DAMAGES WITH PIN TACK THING Lol

Deadly

Get the tack

Put it through orange

Tape about 4 times around

Shoot it at cardboard or a wall - no people plz

Comments

youwiththeface (author)2011-02-03

How the fudge did you put the first step together!!!!!??????

kwonkicker385 (author)2009-07-09

i lyk it!! it's simple,small, and pretty powerful. and the thumb tack thing is fun

DJ Radio (author)2009-06-02

m3h, its ok, 3*

pls (author)2009-06-01

Not to bad, but nothing new.

About This Instructable

760views

2favorites

License:

More by AzNaLaNo:Knex Bow by AzNaLaNo
Add instructable to: