Can fire continuously for ages depending on length of chain.
Long Reload time
USES MODDED PIECES!!!!! AAAARRGGHH!!!
Ahem. Excuse me. I'm surprised you've read this far.
Anyway, Let's start building!
Step 1: Chain
1.Individual bullet (note the 2 chain links)
Step 2: Handle
2.Add Blue and Yellow Rods to one of them.
4.Connect one of them to the thing that you added the Blue and Yellow Rods to. (Picture 2)
5.Add either Y Connectors, Blue Spacers, End Clips OR Grey Connectors on the Blue Rods. Then wrap the wire from the Motor round the Rods.
6-7.Add the other 2 sides back on.
8.Add Blue Rods and Blue Spacers to the controller.
9. Attach it to the rest of the Handle
Step 3: Body
2.Add Green Rods onto the Sticky Outty Things...
3.Make these. They are 5 layers wide.
6.Replace the Orange Connectors with something else if you don't want the Bipod.
7-8.Insert it in and attach the Handle.
9.Attach the other side on now.
10.Get 2 Blue Rods and put them where circled. This will stop the 5 layered things from flopping about.
11.Make This. The Rear Sight. Sorry about the blur.
13.Make this. You don't have to mod the Yellow Rod.
Step 4: Barrel
1.The modded pieces. 4 Grey Rods and 2 Yellow Rods.
2-3.Make this. Use the 2 modded yellows.
4.Make 2 of these. yes they are confusing. I'm sorry i couldn't show you the pattern. I would never be able to put it back again. Either use Snowflakes or try to figure it out for yourself.
8.Attach to gun.
9-10.Now the barrel will be a bit flimsy. So i suggest using a rubber band to pull it up.