Picture of Knex Laptop Stand and Cooling Pad
This is a laptop stand i designed for my dads laptop because it was always overheating

Check out my mods  http://www.instructables.com/id/Knex-Laptop-Stand-and-Cooling-Pad-Mods/
Remove these adsRemove these ads by Signing Up

Step 1: Bottom Base Half

pic 1: what you are making
pic 2: make edge piece
pic 3: side view showing edge pieces
pic 4: make another but the 3-d connectors are turned different
pic 5: showing how connectors are turned
pic 6: last edge piece
pic 7&8: showing the 3-d connectors
pic 9: lining up
pic 10: Connect

Step 2: Angled Suport

Picture of Angled Suport
pic 1: make this
pic 2&3: showing how the orange pieces connect
pic 4: showing where to connect on upside down bottom
pic 5: connected and finished

Step 3: Top Half

pic 1: what your making
pic 2: make this
pic 3: showing 3-d connectors and green pieces
pic 4: make another one the exact same
pic 5&6: make end piece
pic 7: line up
pic 8 attached

Step 4: Laptop Rail

Picture of Laptop Rail
pic 1: make this
pic 2: close up
pic 3: lining up
pic 4: attached

Step 5: Final Assembely

Picture of Final Assembely
pic 1: line up
pic 2: attach and DONE!

comment if you want me to show how to make the adjustable version
Go to my link on the intro to make the mouse pad stand
Nice, laptop could use some space to remove heated air, might build keep it up
rustymia (author)  HomeInventors2 years ago
The open inside design really allows the cooling fans to pull air in and push out the heated air very well. Since he began using this has laptop has been running cooler than when it was just sitting on the dresser.
wde dijk2 years ago
good laptop stand but i have an 11 inch laptop :(
rustymia (author)  wde dijk2 years ago
I think you could make it work if you scaled down everything by one piece. Instead of using yellow rods, use blue rods to make the entire thing that much smaller. It would make the entire stand shorter and narrower so it would fit you smaller laptop better
ElvenChild4 years ago
rustymia (author)  ElvenChild4 years ago
no problem seeing some new laptop stands on instructables are what inspired me to build a laptop stand (again) out of k'nex. Here are some picture I am probably going to enter the stand I just built in the toy contest. ok the uploaders not working so here is a link to a photo instructable that I made for it. http://www.instructables.com/id/knex-laptop-version-12/
GrandeSwag4 years ago
Could use some more supports/side rails. http://knexinnovation.net/showthread.php?850-Macbook-Stand
rustymia (author)  GrandeSwag4 years ago
side rails are not really needed. I feel that they just get in the way and make it harder to place the laptop on the stand and to remove it. If you wanted to you could just make two shorter versions of the front rail and attach them to the side.
looks good, I might build it.
~KGB~4 years ago
not bad at all
rustymia (author)  ~KGB~4 years ago
~KGB~ rustymia4 years ago
no prob