Instructables
Picture of Knex Lever Action Rifle
IMG_0823[1].JPG
IMG_0824[1].JPG
IMG_0825[1].JPG
This gun concept was made by bakenbitz and modded by me.
 
Remove these adsRemove these ads by Signing Up

Step 1: Trigger, Ram Rod, and Mag Rod

Picture of Trigger, Ram Rod, and Mag Rod
IMG_0850[1].JPG
IMG_0836[1].JPG
IMG_0838[1].JPG
IMG_0837[1].JPG

Step 2: Stock

Picture of Stock
IMG_0844[1].JPG
IMG_0845[1].JPG
IMG_0846[1].JPG
IMG_0848[1].JPG
IMG_0849[1].JPG

Step 3: Lever Mech

Picture of Lever Mech
IMG_0826[1].JPG
IMG_0827[1].JPG
IMG_0829[1].JPG

Step 4: Barrel And Assembly

broken white can be replaced with a blue connector

Step 5: Special Note

Picture of Special Note
most cut rods can be replaced with blues or white but in the barrell they must stay cut.
Johnhall441 year ago
Did that a long time ago, didnt post it though. I had it set up so it would pull back the pin and load a round. Im glade that someone finally posted it though =D
Holy cow! How did I miss this?! Awesome job and keep on building.
O sh*t-you made his work
Nice!
CuddlesMcT1 year ago
I built this a very long time ago. Did you ever figure out a way to make the bullet stay in the barrel after it was loaded? Because mine would always slide out.
grimmjowking (author)  CuddlesMcT1 year ago
I just added some tap to increase the friction
grimmjowking (author)  grimmjowking1 year ago
Sorry tape
I guess you can make the top of the barrel, above the lever ramp, a bit looser. So that it acts as a bullet lock,