Knex Nintendo Wii Stand

1,205

3

12

Published

Introduction: Knex Nintendo Wii Stand

About: KNEX FTW!

Hello, and welcome to my Instructable! Today you will learn howto make a long lasting, quality Nintendo Wii stand out of Knex. It's not hard and uses few pieces. Have fun, and let's get started.

Step 1: Piece Count

Here is the piece count  for the stand.

Connectors-
Red - 4
Yellow - 22
White/Black - 30 
Grey/Purple - 28

Rods-
White - 55
Green/Black - 116

You have all the pieces, so go!




Step 2: Sides

Side pieces.

1. Make two of these.
2. Both complete.

Step 3: Base

Base. Everything needs one!

1. Make this.
2. Flipped around view.

Step 4: Connections

Do I really need to give directions?

1. Both side pieces and base.
2. One side piece connected.
3. Both side pieces connected.


Step 5: Finish

There. You're done. Congratulations. That wasn't to bad, wasn't it?

Please comment with any mistakes that I may have made or criticism : ).

/
; ) - Supitsgreg

Share

    Recommendations

    • Water Contest

      Water Contest
    • BBQ Showdown Challenge

      BBQ Showdown Challenge
    • Backpack Challenge

      Backpack Challenge

    12 Discussions

    The wii already comes with a stand why waste your knex making a stand?